Renu

Convertirdores de Señal

 

Datasheet

 

Características
DIN rail or panel mounted compact Converter
Port powered or external powered design
Isolation of power and communication ports
Automatic detection of communication baud rate
Automatic control of transreceiver direction
Easy to use plug and play device (no configuration software required)
CE / UL certification
Especificaciones  
Power + 24 VDC ± 10 %, 2.0 watts max 
(for externally powered model)
Communication Ports Two Ports as Follows:
COM1

COM2		 RS232 / CMOS

RS422 / RS485
Temperature Operating : 0o to 60o C
Storage : -20o to 80o C
Data Rates Upto 115.2 kbps.
Distance Externally powered units transmit data upto 4000 ft (1200 m). Less with port powered model.
Temperature Operating: 0° to 60° C
Storage: - 40° to 90° C
Humidity 10% to 90% (Non condensing)
Mounting DIN rail or back panel mounting
Dimensions (DIN rail) 101mm(L) X 40mm (D) X 51mm(W)
Weight 125 gm approx.
Certifications CE / UL
Immunity to ESD Level 3 as per IEC 1000-4-2
Immunity to Transients Level 3 as per IEC 1000-4-4
Immunity to Radiated RF Level 3 as per IEC 1000-4-3
Immunity to Conducted RF Level 3 as per IEC1000-4-6
Emissions EN55011 CISPR A

 

Models
Model
Power Supply
Isolation
Part Number
Between COM Ports
Between COM Ports & Power
CNV-01
+ 24 V DC or port powered
No
Yes
CNV-01
CNV-02-B
+ 24 V DC external only
Yes
Yes
CNV-02-B
 

CNV-01: CNV-01 is a port-powered (line-powered: RXD+RTS+CTS) or externally powered. In case of point to point communication and if the cable length is less than or equal to 2 mtrs on RS232 side, then external power supply is not needed. This unit takes less than 4mA to operate plus load current. Applications which require a large load current, external + 24V DC power supply on the terminal strip is required. CMOS signals are not supported for CNV-01. Communication ports are not isolated from each other.

CNV-02-B: + 24 V DC power is isolated from communication ports in CNV-02-B model. Both the communication ports are also isolated from each other.
The unit has DB9 female connector on RS232 / CMOS side and PBT on RS422 / RS485 side. RS485 port has 4-wire with signal ground system. Both the models also support 2-wire RS485 communication with signal ground system.
This models is replacement for the CNV-02 (old version model) with following advantages.
1. LEDs for Power and Communication.
2. Shorting of “TX+ & RX+” and “TX- & RX-” not required for 2 wire RS485 configuration.
3. 1.5 KV Surge suppression for RS422 / RS485.
4. User friendly switch settings.

 
 Psg. D’Olot, 121 3er 1era - 17006 Girona - Telf. +34 972 98 73 98 / +34 938 40 25 24 - Fax .+34 938 40 25 03 - Mvl. +34 678 725 255 - info@aptus-hmi.com
Dynisco, weintek, Protech, Weg, Renu, Indusoft, Indumicro, Wachendorff, Xaloy